Sharp AR M207 - B/W Laser - All-in-One Instrukcja obsługi - Strona 31

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wszystko w jednej drukarce Sharp AR M207 - B/W Laser - All-in-One. Sharp AR M207 - B/W Laser - All-in-One 35 stron. Digital multifunctional system

Drukuj stronę

TROUBLESHOOTING

A notice page is printed

If you find that a notice page has been printed at the end of a print job, the print data received from the computer has

not been printed as specified. Fix the problem as explained below and then try printing again.

What to do when a notice page is printed

****************************************************

Notice Page

****************************************************

The IMC memory full error had occurred,

a normal output was not able to be executed.

Please refer to the operation manual for

the solution method.

The above notice page is printed when a print job

containing more data than can be held in the memory

of the dual function board is sent. Deactivate the

ROPM function by removing the checkmark from

[ROPM] in the [Configuration] tab of the printer driver

setup screen. If you need to use the ROPM function,

set the "Print quality" in the printer driver to [Draft], or

increase the amount of memory in the machine.

SCANNING PROBLEMS

Problem

Poor scanning

quality.

Cause and solution

The document glass or the underside of the document

cover/SPF is dirty.

→ Clean regularly.

The original is smudged or blotchy.

→ Use a clean original.

You have not specified a suitable resolution.

→ Make sure that the resolution setting in the scanner driver is

appropriate for the original.

You are scanning a large area (for example an entire 11" x

17" or A3 document) at high resolution.

→ If you attempt to scan a large area at high resolution and there is insufficient

memory in the machine to hold the scanned data, scanning will take place at

a lower resolution and the scanner driver will enhance the data to make up

for the lower resolution. However, the quality of the enhanced image will not

be as high as if scanning took place at the higher resolution. To scan a

ledger or A3 original in full color at 600 dpi without using enhancement, the

dual function board and 256 MB memory option are required.

You have not specified a suitable value for the "B/W

Threshold" setting.

→ If you are using a TWAIN-compliant application and are using

[White], [Red], [Green], or [Blue] for "Light Source" in the TWAIN

driver, make sure that the "B/W Threshold" setting is appropriate. A

larger threshold value makes your output darker, while a small

threshold value makes it lighter. To adjust the threshold

automatically, click the [Auto Threshold] button on the [Image] tab of

the "Custom Settings (or Professional)" screen.

• The Notice Page can be set to not print

Note

out in

"NOTICE PAGE" (page 26)

key operator programs.

When the dual function board is installed

• The memory of the dual function board is used

to temporarily hold print data when the ROPM

function is used. This memory is also used to

temporarily store the image of the original during

copying. The proportion of memory allocated to

the printer function can be changed in the key

operator programs. See the "Key operator's

guide". The memory can also be increased by

adding the optional memory modules. For

details, contact your SHARP dealer.

When the dual function board is not

installed

• A notice page such as "The incorrect driver

is chosen, a normal output was not able to

be executed....." will be printed if you

attempt to print using the print driver for the

dual function board. Install the standard print

driver as explained in "1. INSTALLING THE

SOFTWARE (THAT ACCOMPANIES THE

MACHINE)" in the "Software setup guide"

and select the standard driver when printing.

of the

Page

Operation manual (for

general information

and copier)

–