Sharp AR-M276 Instrukcja obsługi klucza - Strona 20

Przeglądaj online lub pobierz pdf Instrukcja obsługi klucza dla Wszystko w jednej drukarce Sharp AR-M276. Sharp AR-M276 24 stron. Digital multifunctional system
Również dla Sharp AR-M276: Instrukcja konfiguracji oprogramowania (18 strony), Instrukcja konfiguracji oprogramowania (20 strony), Specyfikacje (9 strony)

Drukuj stronę
Sharp AR-M276 Instrukcja obsługi klucza
PROGRAMS FOR PRINT MODE

PORT SWITCHING METHOD

(When the PRINTER EXPANSION KIT is installed)
This program is used to set the method for switching
printer ports.
The machine can use the following three printer ports:
• Parallel port
• USB port
• Network port
Selections
SWITCH AT
Automatic printer port selection
END OF JOB
at the end of each print job.
SWITCH AFTER
Automatic printer port selection if
I/O TIMEOUT
the time set in "I/O TIMEOUT"
elapses.
ENABLE PARALLEL PORT
(When the PRINTER EXPANSION KIT is installed)
This program is used to enable or disable printing via
the parallel port.
ENABLE USB PORT
(When the PRINTER EXPANSION KIT is installed)
This program is used to enable or disable printing via
the USB port.
ENABLE NETWORK PORT
(When the PRINTER EXPANSION KIT is installed)
This program is used to enable or disable printing via
the network port.
ENABLE ECP
(When the PRINTER EXPANSION KIT is installed)
Enable this program when you wish to use ECP mode
on the parallel port.
18
Description

NETWORK SETTINGS

(When the PRINTER EXPANSION KIT is installed)
The NETWORK SETTINGS are used when the
machine is used as a network printer. The "NETWORK
SETTINGS" consist of the following programs:
● IP ADDRESS SETTING
● ENABLE TCP/IP *
● ENABLE NetWare *
● ENABLE EtherTalk *
● ENABLE NetBEUI *
● RESET THE NIC
* When the PRINT SERVER CARD is installed.
Consult your network administrator
Caution
before configuring the NETWORK
SETTINGS.
• After changing the settings, you must turn
Note
off the machine's power switch, wait
briefly, and then turn the switch back on in
order to make the changes take effect.
• Some programs in the following are
marked by "*1". This indicates that a
message will appear at the end of the
setting procedure asking you to confirm
execution of the new setting. If needed,
you can cancel the new setting by
touching the [NO] key.

IP ADDRESS SETTING

This program is used to set the IP address (IP
address, Subnet Mask, and Gateway) of the machine
when TCP/IP protocol is used on the network.
When "DHCP" is selected, the machine will obtain an IP
address automatically. This is the factory default setting.
When the print server card is installed and the
machine is used on a TCP/IP network, be sure to
enable the "ENABLE TCP/IP" program.
When DHCP is used, the IP address
Caution
assigned to the machine may
automatically be changed on
occasion. If this happens, printing
will not be possible.
ENABLE TCP/IP
This program must be enabled to use the machine on
a TCP/IP network. "IP ADDRESS SETTING" must
also be configured.
ENABLE NetWare
This program must be enabled to use the machine on
a network that uses NetWare protocol.
ENABLE EtherTalk
This program must be enabled to use the machine on
a network that uses EtherTalk protocol.