AccuTemp XLR8 Instrukcja instalacji i obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Urządzenia przemysłowe AccuTemp XLR8. AccuTemp XLR8 13 stron. Upper heated platen
Drukuj stronę
4.3 COOKING
4.3.1 CLEAN AFTER INSTALLATION
It is recommended that you clean your
XLR8 thoroughly before using it for the first
time. To clean the equipment teflon cooking
surface, just simply wash it down with a solution
of mild soap and water, then rinse thoroughly
with clean water and wipe dry with a clean
towel.
Please use caution as temperatures
on and around the griddle cooking
surface could cause severe burns.
4.3.2 PREHEATING
Press the
and select the desired preset.
ON/OFF
The upper platen should be approximately 40-
50F hotter than the griddle surface to achieve
good caramalization on product.
The equipment will be preheated when the
selected set temperature is displayed and the
corresponding LED goes solid. Please use
caution as temperatures on and around the
cooking surface could cause severe burns.
4.3.3 ADJUSTING THE PLATEN GAP
HEIGHT
The XLR8 arm has gap adjustment every 1/32nd
of an inch. This gives you the control needed to
adjust to any product up to 2" thick. To adjust
the gap remove the adjustment arm in the
front of the Upper Heated Platen. Raise the arm
and place the desired product in the middle
of the platen coverage area. With the griddle
and arm on and preheated, lower the arm until
you start to hear a sizzle from the product.
This means you are applying slight pressure on
the top of the product. At this point, install the
adjustment arm onto the mounting plate. Place
the lock bolt into the hole that lines up with the
mounting plate and tighten.
SP8144-2011
4.3.4 COOKING
If a recipe is provided for the product you
are preparing, always follow your company
guidelines for preparing product.
If adjusting your own recipe to incorporate the
use of the XLR8 it is recommended to apply the
following steps:
•
Divide the total cook time applied to a
product cooking on just the griddle surface
by half. Adjust the time from there until you
are happy with the finished product.
•
Once you have the time and temperature
for the product identified, use the
programming instructions to set the timer
and presets accordingly.
•
Adding more compression (smaller gap
between platen and griddle surface) will
decrease cook time but may result in a dryer
product.
4.3.5 CLEANING
•
Power unit off and allow to cool until it is
safe to touch, approximately 30 minutes.
•
Remove teflon sheetand clean using mild
soap and water solution and a towel.
•
To clean the arm, once cooled, clean using
mild soap and water solution and a towel.
Rinse when done with clean water and allow
to dry overnight.
Do not Power Spray the griddle or XLR8
Upper Heated Platen. A non-Metallic
cleaning pad can be used to remove large
debris or built up areas.
XLR8 Installation & Operation Manual
10