Digit-KD VISION series Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Keypad Digit-KD VISION series. Digit-KD VISION series 12 stron. Remote keypad with lcd display
Drukuj stronę11.0. BY-PASSING ZONES
With the control panel disarmed (OFF), proceed as follows:
Digit any one of the memorized
codes (example 7, 8 and 9). On
the display 3 asterisks will appear.
Press the button
The writing "ON" will flash quickly.
Before the writing "delay" appears, press
the button
The LED "TEST" will light. A message that
indicates the status of the first zone will
appear on the display.
In the case that the zone is not by-passed, the above message will be visualized.
By pressing the button
by-passed. The message on the right will
appear on the display.
By newly pressing the same button, the
zone will be re-armed and so forth.
To pass to the next zone, press the button
A message regarding the status of the
second zone will appear on the display.
To by-pass the zone, press the button
Repeat operations 4) and 5) for all zones to by-passing.
If a few zones are by-passed, during the exit time on the display
the message "zone by-p" instead of "delay" will appear.
To verify the zones by-passed, press more
times the button "FORWARD" during the
exit time. On the display the menu (in
groups of 4) are visualized with the
complete list of all zones, plus Bat (low
battery), Tmp (Tamper) and Firendio (fire).
Next to each by-passed zones a dot will
appear that flashes quickly.
To exit by-passing zones at any moment,
press more times the button
display the message of control panel
disarmed (OFF) will appear.
Digit-KD instruction manual
to confirm.
.
, the zone will be
until on the
ENGLISH
OFF
OK
***
ON
OK
BY-PASS
zone
1 : no
BY-PASS
zone
1 : si (yes)
BY-PASS
.
zone
2 : no
.
BY-PASS
zone
2 : si (yes)
ON
zone by-p
OK
5
ON
7
In the above example, the
zones 7 and 8 are by-passed.
OFF
OK
6
8
Pag. 11