Digital Acoustics INT-IP-2GANG Podręcznik dla początkujących - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla System interkomu Digital Acoustics INT-IP-2GANG. Digital Acoustics INT-IP-2GANG 4 stron.
Również dla Digital Acoustics INT-IP-2GANG: Podręcznik dla początkujących (3 strony)
Drukuj stronę
Installation
The INT-IP-2Gang can be flush mounted into a standard 2-gang electrical box
or surface mounted in an optional surface mount box. A hooded surface
mount box is recommended for outdoor installations.
Please note, the
•
If the relay will be used to activate an electronic door strike, connect
the COM (B2) and either the NO (B1) or NC (B3) to the door strike
•
Connect RJ-45 (B4) to a PoE (802.3af) network switch or injector.
The INT-IP-2GANG will power up within 5 seconds and request 7.0
watts from the Power Source Equipment
•
The green Link LED (B5) will turn solid. The yellow Ready LED
(B6) and the Call button LED will flash 4x per second
•
Record the ID# from the label on back of the INT-IP-2GANG for use
during software configuration. Optionally, label the panel with one
of the extra ID# labels
•
Install the Call Station in the 2-gang electrical box with the call
button in the upper left-hand corner so the RJ-45 connector faces
down
•
Fasten using the four security screws (T10)
•
Use a high-quality silicone sealant between the top and sides of the
unit and the surface it is mounted to
•
The Call Station LED will continue to flash till configuration is
complete
•
Please refer to the INT-IP-2GANG_ReferenceManual available at
https://www.digitalacoustics.com/support/ip7-hardware-talkmaster-
software-manuals/ for additional information on installation
can be configured before being installed.
INT-IP-2Gang