Sharp SJ-WP32T Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lodówka Sharp SJ-WP32T. Sharp SJ-WP32T 12 stron. Refrigerator-freezer

Drukuj stronę

INSTALLATION

WARNING
■
Do not install the refrigerator in a damp or wet location as
this may cause damage to the insulation. Condensation
may also build on the outer cabinet and cause rust.
1
Keep adequate ventilation space around the refrigerator.
•
The figure shows the minimum required space for
installing the refrigerator. The amount of space around
the refrigerator affects the amount of power consumption.
•
Insufficient spacing will decrease cooling efficiency
and increase energy consumption. This may reduce
the life of the unit and void warranty.
90mm
or more
60mm
or more
Free standing type
2
Using the two front adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
3
Clip the foot cover (supplied inside the refrigerator
compartment) in position in front of the two adjustable
feet.
4
Connect the power plug to a 230/240 volt. 10 amp.
power point.
NOTE
•
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
This refrigerator is designed for indoor use only, do not place
the unit on an unsealed surface.
•
To avoid vibration and misalignment of the doors, the unit
must be level. Place the unit on a solid flat surface. Uneven
floors eg. slate, tiles and floorboards, can cause the unit to
sag over time causing the doors to become misaligned.
•
If the mains power is switched on when the door is open, the
door alarm will sound. Close the door to stop the alarm.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
4
60mm
60mm
or more
1350mm
Adjustable foot
Foot cover
Before transporting
•
Wipe up water in the evaporating pan.
Before wiping up the water, wait more than 1 hour after
pulling out the plug because refrigeration cycle equipment
is extremely hot.
(The evaporating pan is located on the rear of the product.)
NOTE
•
Do not bend or damage the ductwork located on the inside of
or more
the evaporating pan. It may cause failure.
When transporting
•
The casters allow the refrigerator to move and forth.
•
Carry the refrigerator by holding the handles located on
the rear and bottom.
Casters
(4 pcs.)
When the door is heavy to open
When one side door is heavy
•
When the left side is heavy, lower the right side adjustable
foot.
(Until the opposite side adjustable foot is slightly off-ground.)
Heavy
•
When the right side is heavy, lower the left side adjustable
foot.
When both sides are heavy
•
When the refrigerator is tilted backwards insert a wooden
board (with relatively large width), etc. between the rear of
the refrigerator and the floor to adjust the tilting.
Front
Evaporating pan
rear
bottom
Adjustable foot
Back
A wooden board
(with relatively large
width)