Sharp Notevision XG-C435X-L Instrukcja konfiguracji - Strona 19

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Projektor Sharp Notevision XG-C435X-L. Sharp Notevision XG-C435X-L 46 stron. 4000 ansi lumens conference series projector
Również dla Sharp Notevision XG-C435X-L: Arkusz specyfikacji (2 strony), Specyfikacje (2 strony)

Drukuj stronę

1. Connecting the Pro-

jector to a Computer

Establishing a one-to-one connection from the

projector to a computer. Using a commercially

available LAN cable (UTP cable, Category 5,

cross-over type) you can configure the pro-

jector via the computer.

Disconnect the computer's LAN

cable from the existing network.

Connect a commercially avail-

able LAN cable (UTP cable, Cat-

egory 5, cross-over type) to the

projector's LAN terminal and

connect the other end of the

cable to the computer's LAN

terminal.

Plug the power cord into the AC

socket of the projector.

Turn on the computer.

Info

Confirm that the LINK LED on the rear of the

projector illuminates. If the LINK LED does not

illuminate, check the following :

• The LAN cable is properly connected.

• The power switches of both the projector

and the computer are on.

This completes the connection. Now proceed to "2. Setting an IP Address for the Com-

puter".

Setting up the Projector Network Environment

A LAN cable being

connected to the network

(cross-over type, commercially available)

LAN cable

-19