DIGITAL ALLTEK WI-CONNECT PRO Instalacja i skrócona instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instalacja i skrócona instrukcja obsługi dla Antena DIGITAL ALLTEK WI-CONNECT PRO. DIGITAL ALLTEK WI-CONNECT PRO 8 stron. Wireless adaptor/antenna
Drukuj stronęDIGITAL ALLTEK
Click on the "Available Network" tab and the window
shown in Figure 19 will appear which lists all of the
available wireless networks that the WI-CONNECT
PRO can detect. Select the wireless network that you
wish to connect to and click the "Add to Profile" button.
You will now be prompted to enter the Network Key
(also known as Password, WEP key or Passphrase) for
the network that you have selected. Consult the
network operator to get the necessary password and
enter this in the two boxes at the bottom of the window
shown in Figure 20. Click "OK".
Assuming that the password was correct, the WI-
CONNECT PRO should connect to the network and you
will see the window shown in Figure 21.
If you click on the "General" tab you should see the
window shown in Figure 22 which gives the wireless
connection status.
.
Figure 21
6. Installing and Operating the WI-CONNECT PRO on a Mac
Insert the WI-CONNECT PRO Drivers/Software Memory Stick in to your Apple Mac and using Finder open the folder
called MacOS10.4, MacOS10.5, MacOS10.6 or MacOS10.7 depending upon the version of Mac OS X you have.
Included in each of these folders is an Installer.pkg package that you can double click on to install.
For OSX 10.8 (Mountain Lion) use the Installer in the MacOS10.7 folder which is a 64bit driver and has been
successfully tested with Mountain Lion.
When you run the Installer.pkg file, the first screen that you see will be the one shown in Fig 23. Click "Continue" for
this screen and the next couple of screens that are displayed. You will be asked to enter your Administrator password
and then the installation will start and you will see a progress bar as shown in Fig 24.
WI-CONNECT PRO PRO Quick Start Guide
Figure 20
Figure 22