Shimano BR-IM35 Podręcznik sprzedawcy - Strona 20
Przeglądaj online lub pobierz pdf Podręcznik sprzedawcy dla Akcesoria rowerowe Shimano BR-IM35. Shimano BR-IM35 27 stron. Hub roller brake
Drukuj stronę
- 1. Table of Contents
- 1. Important Notice
- 2. To Ensure Safety
- 3. Installation
- 3. List of Tools to be Used
- 3. Installation of the Lever
- 3. Installing the INTER M Brake to the Hub Body
- 3. Installation of the Hub to the Frame
- 3. Installation of the Brake Cable
- 4. Adjustment
- 4. Adjusting the Brake Cable
- 5. Maintenance
- 5. Applying Grease
INSTALLATION
Installation of the brake cable
6
(O)
7
(P)
8
9
(e)
10
Hook the inner cable (M) over the
cable hook (L).
(M)
(L)
Insert the outer holder unit (O) into
the hole of the brake arm (N) from
underneath and slide it to the lower
(N)
section of the hole.
After checking that the outer holder
unit (Q) is inserted as far as it will go
into the guide slot in the brake arm,
install the inner end cap (P).
(Q)
Then, set the inner end cap so that it
does not touch the fin or the spokes.
Turn the cable adjustment barrel (R) to
tighten the inner cable.
(R)
After pressing the lever, check that the
red marks on the inner cable fixing
washer with the inner cable mounting
bolt unit press-fit into the winder unit
are in the right direction as shown in
the illustration.
(e)
Red
(e)
20
(L)
Cable hook
(M)
Inner cable
(N)
Brake arm
(O)
Outer holder unit
(P)
Inner end cap
(Q)
Outer holder unit
(R)
Cable adjustment barrel
Installation of the brake cable can be
completed by the above procedure. When
detaching the cable, perform in reverse
order.