Digital Barriers EDGEVIS HD-IP150 Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Konwerter mediów Digital Barriers EDGEVIS HD-IP150. Digital Barriers EDGEVIS HD-IP150 15 stron.

Drukuj stronę

EDGEVIS HD-IP150 HARDWARE INSTALLATION GUIDE

Default LAN port IP Addresses

For ease of deployment each LAN port on the HD-IP150 device is pre-configured with a static IP address:

LAN Port

USB Ethernet

Connecting IP cameras

The HD-IP150 allows for connection of two IP cameras via either of the LAN ports located on the front of the unit. Each

camera should be connected to the device using standard Ethernet cable and it should be powered by its own power

supply. Two ports are provided to allow separate connections between the HD-IP150 and the IP Cameras and internet

connection (e.g. an ADSL or SatCom router).

Refer to Section 1 of the IP Series, HD-Q800, 4K-R800 - Setup Guide for details on configuring the Ethernet ports and

IP cameras to work together. The list of specific cameras supported on the IP Series of products can be found on the

Support site:

http://tvi-support.digitalbarriers.com

Storage medium

The HD-IP150 supports either an internal solid state disk (SSD) or hard disk drive (HDD). An SSD drive is recommended

for greater reliability, particularly if using the HD-IP150 for vehicle-based applications. The disk can be removed only

when the unit is powered off.

Additionally, it is possible to use external USB disks to store recordings. For further details, refer to Section 2 of the IP

Series, HD-Q800, 4K-R800 - Setup Guide v8.0.

Updating the software on the unit

Once notified of a new software release by Digital Barriers, updates are available for download from the EdgeVis

support site (see below for link) for installation onto the device.

There are three ways to update the firmware:

•

To update remotely, upload the new firmware to the Firmware tab within the EdgeVis Server web interface

and then, from the Encoder tab, select Upgrade Firmware from the Select Action menu on the desired

encoder.

•

Using the Upgrade Firmware option when logged into the encoder's local web interface.

•

Copy the firmware onto a USB flash drive and insert into a USB port on the front of the unit. The flash drive

can be inserted into a running unit or before the unit is powered up. The update procedure will take

approximately ten seconds, and then the encoder will beep four times. At this point it is safe to remove the

pen and the unit will automatically reboot. If the update fails the encoder will beep continually.

To access or register for the Digital Barriers Support Site, visit

ISSUED: 10 NOVEMBER 2020

Default IP Address

LAN1

192.168.10.1

LAN2

192.168.11.1

192.168.12.1

Subnet mask

255.255.255.0

tvi-support.digitalbarriers.com

PAGE 6