Actron OBD II PocketScan Code Reader CP9125 Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt testowy Actron OBD II PocketScan Code Reader CP9125. Actron OBD II PocketScan Code Reader CP9125 10 stron. Obdii pocketscan code reader
Drukuj stronę
NOTE: If there are no more
I/M monitors that are incom-
plete, the tool will then
display ready monitors when
is pressed .
10 . View I/M monitors that are
ready .
•
Press and release
NOTE: Pressing
scroll up to review diagnostic
trouble codes and data .
Holding
seconds will read diagnostic
trouble codes and data again .
Erasing Diagnostic Trouble
Codes and Data
Erasing allows the PocketScan®
code reader to delete the codes and
IM monitor status from the vehicle's
computer modules .
NOTICE
Only erase diagnostic data
after checking
system completely and
writing down results .
.
will
down for 3
| CP9125 | User guide | 9
WARNING!
Avoid cooling fan . Fan
may turn on during test .
1 . Turn ignition key to the OFF
position .
2 . Locate and plug in data link
connector (DLC) .
NOTE: The data link connector
should be located under the
dashboard on the driverside of
the vehicle . If the data link
connector is not located under
the dashboard as stated, a label
describing the location of the
data link connector should be
there .
3 . Observe display toggles between
"Pocket" and "Scan" .
4 . Turn ignition key to the ON
position leaving engine off .
NOTE: Make sure that the igni-
tion key is ON and NOT in the
accessory position .