DIGITAL DELAY Mega 60 Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca DIGITAL DELAY Mega 60. DIGITAL DELAY Mega 60 9 stron. W/ 4 stage timer

Setting Push-button Mode and the

To set the Push-button Mode, press the 4 key, the Push-button Mode is shown on the left screen. The left most digit

shows "1", " 2" or "3" to indicate which Push-button Mode the unit is in, when in Push-button Mode 3, the P.B. 1 on terminal

strip starts both the primary and secondary delays, this is done by pressing and then releasing the pushbutton on the first

desired yellow light to start delay one. Then repressing the same pushbutton and releasing on the second desired yellow light is

done to start delay 2. Care should be taken not to flinch in pushbutton mode 3 because the box will think you released, and the

car will roll out of the beams causing a red light even if you are pressing the pushbutton. When in Push-button Mode 2, one or

both push buttons can be used in any sequence, the First P.B. starts the primary and

When in Push-button mode 1 the pushbutton wired to pushbutton 1 on the terminal strip will only be used to hit the tree once.

The two right digits show the programmable amount of time (00 to 99 seconds) that after the Transbrake releases, Button 1 and

Button 2 push-button inputs are disabled. To change pushbutton mode or the Interrupt Time first arrows to that screen side,

followed by pressing the arrow keys will change the pushbutton mode. To change the Push-button interrupt time press the

CLEAR key, then enter the desired number value. For example "1 10" would indicate 1 Push-button Mode with a 10 second

Interrupt Time. If no Push-button Interrupt Time is wanted enter "00".

Note: Only in pushbutton mode 1 or 3 can the push button 2 terminal be used as the tap button input.

A by-pass push-button is used to engage the Transbrake solenoid without starting a timing cycle. This can be helpful

if the vehicle needs the Transbrake engaged to back up. If a by-pass push-button is desired, connect one side of a push-button

to the Transbrake terminal and the other side of the push-button to +12 Volts.

Applying 12 Volts to any of the outputs will not damage the unit.

Connecting or shorting any output terminal directly to ground will cause damage to the unit. This damage will

not be covered by the warranty. It is strongly recommended that a 15 Amp fuse be put in each of the wires coming

from the output terminals.

Push-button Interrupt Time

PUSHBUTTON MODE 1: Means one button for one hit at tree.

PUSHBUTTON MODE 2: Means two push buttons for two hits at tree.

PUSHBUTTON MODE 3: Means one pushbutton for two hits at tree.

Understanding and Connecting

a By-pass push-button

econd P.B. starts the secondary delay.