Bitspower Notos Xtal 120 Fan Digital RGB Instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt komputerowy Bitspower Notos Xtal 120 Fan Digital RGB. Bitspower Notos Xtal 120 Fan Digital RGB 9 stron.
Drukuj stronę
Gnd
Din
NC
Pwm
Fg
Nc
Gnd
1
Controller
2
SATA cable
Remote control
Key functions :
(Battery type : CR2025)
1.Control mode : Remote
2.Static brightness : 5 levels
3.Dynamic speed : 7 levels
4.Number of modes : 100 dynamic modes, 11 static modes
5.Power-off memory : Mode, brightness, and speed settings are retained after powering off
6.External speed regulation : The speed of all fans is regulated by an external PWM signal.
7.One-to-one matching lock: Press and hold the white button for 5 seconds to activate the one-to-one matching
Connector Headers :
ⓐ Power input : LED voltage +5V. Rated current: MAX. 6A
ⓑ DRGB control : For an LED signal input, the LED strip will show various lighting effects according to the external signal.
ⓒ LED1-LED5 ： For signal output to the LED strip.
ⓓ FAN1-FAN5 ： FAN1 (red), detects the fan speed. FAN2-FAN5, used for simultaneous operation of multiple fans.
ⓔ Fan speed control: External fan speed signal input, providing PWM signal to control the five fans.
ⓕ 2-pin signal switch: For switching between MCU and external signals.
Notice :
● Please confirm the power voltage before turning the power on.
● Rated Voltage (Fan): DC 12V
● Rated Voltage (LED): DC 5V
Specification ：
Controller Hub Specifications
Rated Voltage: DC 12V
Rated Current: <10mA
FAQ :
The remote controller does not work
3
4
3
DRGB cable (connects to the motherboard)
4
Fan cable (connects to motherboard)
lock mode. Press and hold the purple button for 5 seconds to unlock the mode.
Fan voltage +12V. Rated current: MAX. 8A
The LED signals of the controller and the motherboard can be toggled using the "RC/MB" button on
the remote control.
Short circuit for 3-5 seconds: the external signal controls each LED strip.
Short circuit for 1 second: the MCU signal controls each LED strip.
Fault conditions
LED strip does not work
External input does not work
Single interface does not work
The fans does not work
Single fan does not work
Analysis
The cable is not connected
Power supply failure
The signal cable is not connected
The signal has short-circuited
The signal cable is not connected
LED strip failure
LED strip is not connected
The power cable is not connected
power supply failure
The signal cable is not connected
The fan failure
The power cable is not connected
The battery is empty
Bad remote control or controller failure Replace the remote control or controller
[ 2 ]
Installation
1
2
Solutions
Reconnect the cable
Replace the power supply
Reconnect the signal cable
Find where the short-circuited point is
Reconnect the signal cable
Replace the LED strip
Reconnect the LED strip
Reconnect the cable
Replace the power supply
Reconnect the signal cable
Replace the fan
Reconnect the cable
Replace the battery