Siemens 3200 Series Instrukcja obsługi interfejsu operatora - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi interfejsu operatora dla Urządzenia przemysłowe Siemens 3200 Series. Siemens 3200 Series 4 stron. Room units with analog outputs
Drukuj stronę
Document No. 125-706
Operator Interface Guide
September 19, 2017
Sensor Set-up
Figure 3. Circuit Board
(Located inside Room Unit Cover.
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models
as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.
© 2017 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA
+1-847-215-1000
1.
·
·
2. If selecting voltage, set the jumper as follows:
·
·
Your feedback is important to us. If you have
comments about this document, please send them
to
If the device has a switch, determine if voltage or
current output is needed.
For current, set the switch in the down position
(I).
For voltage, set the switch in the up position
(V).
Use the top and middle pins for 0 to 5V.
Use the bottom and middle pins for 0 to 10V.
Document No. 125-706
Printed in the USA
Page 4 of 4