Siemens SIMATIC S7-200 Podręcznik kierowcy - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik kierowcy dla Urządzenia przemysłowe Siemens SIMATIC S7-200. Siemens SIMATIC S7-200 28 stron. Ethernet gateway for simatic mpi/ profibus driver
Również dla Siemens SIMATIC S7-200: Podręcznik (30 strony), Podręcznik (35 strony), Podręcznik (49 strony), Podręcznik (18 strony), Instrukcja obsługi systemu (20 strony)

Drukuj stronę

Siemens SIMATIC S7-200 Podręcznik kierowcy

Siemens S7-200 Driver

Communications Timeouts

Connect Timeout: This property (which is used primarily by Ethernet based drivers) controls the amount of

time required to establish a socket connection to a remote device. The device's connection time often takes

longer than normal communications requests to that same device. The valid range is 1 to 30 seconds. The

default is typically 3 seconds, but can vary depending on the driver's specific nature. If this setting is not

supported by the driver, it is disabled.

Note: Due to the nature of UDP connections, the connection timeout setting is not applicable when

communicating via UDP.

Request Timeout: This property specifies an interval used by all drivers to determine how long the driver

waits for a response from the target device to complete. The valid range is 50 to 9,999,999 milliseconds

(167.6667 minutes). The default is usually 1000 milliseconds, but can vary depending on the driver. The

default timeout for most serial drivers is based on a baud rate of 9600 baud or better. When using a driver

at lower baud rates, increase the timeout to compensate for the increased time required to acquire data.

Attempts Before Timeout: This property specifies how many times the driver issues a communications

request before considering the request to have failed and the device to be in error. The valid range is 1 to

10. The default is typically 3, but can vary depending on the driver's specific nature. The number of attempts

configured for an application depends largely on the communications environment. This property applies to

both connection attempts and request attempts.

Timing

Inter-Request Delay: This property specifies how long the driver waits before sending the next request to

the target device. It overrides the normal polling frequency of tags associated with the device, as well as

one-time reads and writes. This delay can be useful when dealing with devices with slow turnaround times

and in cases where network load is a concern. Configuring a delay for a device affects communications with

all other devices on the channel. It is recommended that users separate any device that requires an inter-

request delay to a separate channel if possible. Other communications properties (such as communication

serialization) can extend this delay. The valid range is 0 to 300,000 milliseconds; however, some drivers may

limit the maximum value due to a function of their particular design. The default is 0, which indicates no

delay between requests with the target device.

Note: Not all drivers support Inter-Request Delay. This setting does not appear if it is not available.

Device Properties — Auto-Demotion

The Auto-Demotion properties can temporarily place a device off-scan in the event that a device is not

responding. By placing a non-responsive device offline for a specific time period, the driver can continue to

optimize its communications with other devices on the same channel. After the time period has been