Digital Equipment DEC LANcontroller 601 Rozwiązywanie problemów - Strona 6

Przeglądaj online lub pobierz pdf Rozwiązywanie problemów dla Kontroler Digital Equipment DEC LANcontroller 601. Digital Equipment DEC LANcontroller 601 7 stron.

Drukuj stronę
B
Performing a Module Loopback Test
NIC:
(a)
Slide up
clip
(b)
Loopback
connector
1.
Move the NIC
switch down.
4.
Wait until the READY
LED stops flashing
(max. 2 min).
3. If the test passes, LEDs show the READY state.
If the test fails, LEDs show the ATTENTION or FAULT state.
6
1. Attach the Ethernet
loopback
(H4080) to the NIC
port or Ethernet cable.
2. Run the module loopback test:
2.
Wait until the hot-
swap LED lights up
(approx. 2 s).
5.
Observe the test
result
LED display.
flash
Ethernet cable:
(a)
Slide up
clip
connector
(b)
Loopback
connector
3.
NOTE
on
the
If loading has been
disabled for this slot,
the READY LED will
not stop flashing. To
enable the slot, see
the
no
Network Integration
flash
Server
ment.
Ethernet
connection
device
Move the NIC
switch up.
manual
DEC
Manage-
LKG–5727–91I
LKG–5732–91I