Siemens 17 Części zamienne i instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Części zamienne i instrukcja obsługi dla Kontroler Siemens 17. Siemens 17 6 stron. Combination starters

Replacement Parts and Instruction Guide

Instruction Guide

NOTE:

Not typical for all size switches

Circuit Breaker Assembly Instructions

Remove the (2) screws from the connecting link.

Use a 5/16" wrench to remove the two 1/4-20 screws and

lock washers which secure the handle to the enclosure

flange. These screws are located on the underside of the

enclosure flange. Remove the old handle assembly from

the enclosure.

Remove the mechanism from the panel and replace it

with the one provided. The mounting panel may need to be

removed to access the mounting screws.

Hardware has been provided to mount a new disconnect

switch if necessary.

Siemens Industry, Inc. 3617 Parkway Ln, Peachtree Corners, GA 30092 www.usa.siemens.com

Disconnect Handle Replacement Diagram

E87010-A0137-T003-A4

Install the new handle assembly onto the enclosure.

Reinstall the two 1/4-20 screws and lock washers.

Make sure the handle housing is sealed against the

enclosure flange as this prevents the entry of moisture.

Reinstall the connecting pin and retaining ring that connect

the handle link to the mechanism. The retaining ring should

not spin freely on the shaft after it is installed.

No handle adjustment is required.

Verify that the handle mechanism turns 'ON' and 'OFF' the

circuit breaker.

10. Verify that the door cannot be opened with the handle in

the 'ON' position.

A5E31166526A-003