Cisco WS-X45-SUP9-E Uwaga dotycząca instalacji i konfiguracji - Strona 13

Przeglądaj online lub pobierz pdf Uwaga dotycząca instalacji i konfiguracji dla Przełącznik Cisco WS-X45-SUP9-E. Cisco WS-X45-SUP9-E 22 stron.

What to Do Next

Install the blank slot cover or a replacement supervisor engine.

Installing the Supervisor Engine

Warning

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when

servicing. Statement 1034

To prevent ESD damage, handle supervisor module by the carrier edges only.

Caution

Before You Begin

• Verify chassis compatibility and slot restrictions.

◦Catalyst 4503-E—Slot 1 only

◦Catalyst 4506-E—Slot 1 only

◦Catalyst 4507R+E—Slot 3 and slot 4 (redundant supervisor engines supported)

◦Catalyst 4510R+E—Slot 5 and slot 6 (redundant supervisor engines supported)

• Verify that both the supervisor engines (in a redundant configuration) are of the same type.

Procedure

Step 1

Take the necessary precautions, to prevent ESD damage. Wear a grounded ESD wrist strap while handling the modules,

and keep them in ESD-protective bags when they are not installed in a chassis.

Step 2

Ensure that you have enough clearance to accommodate any interface equipment that you will connect directly to the

supervisor module ports.

Step 3

Remove the existing module

• If a switching module filler plate is present, loosen the two captive installation screws that secure the switching-module

filler plate and remove it. Save it for future use.

• If you are removing an existing supervisor engine, see

In a redundant configuration, if you are replacing both supervisors with a different model, remove both supervisor

Note

engines before installing either one of the new models.

Removing the Supervisor Engine, on page

12.