Samsung 2233BW - SyncMaster - 22" LCD Monitor Skrócona instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Monitor Samsung 2233BW - SyncMaster - 22" LCD Monitor. Samsung 2233BW - SyncMaster - 22" LCD Monitor 16 stron. Quick guide (korean)
Również dla Samsung 2233BW - SyncMaster - 22" LCD Monitor: Specyfikacje (2 strony), (Skrócona instrukcja obsługi (16 strony), (Koreański) Skrócona instrukcja obsługi (22 strony)

Drukuj stronę

Useful Tips

A monitor recreates visual signals received from the computer. Therefore, if there is a problem

with the computer or the video card, this can cause the monitor to become blank, have poor

coloring, become noisy, and video mode not supported, etc. In this case, first check the source

of the problem, and then contact the Service Center or your dealer.

Judging the monitor's working condition

If there is no image on the screen or a "Not Optimum Mode", "Recommended Mode 1680

x 1050 60 Hz" message comes up, disconnect the cable from the computer while the monitor

is still powered on.

If there is a message coming up on the screen or if the screen goes white, this means the

monitor is in working condition.

In this case, check the computer for trouble.

Check List

Note

Before calling for assistance, check the information in this section to see if you can remedy

any problems yourself. If you do need assistance, please call the phone number on the In-

formation section or contact your dealer.

No images on the screen. I cannot turn on the monitor.

Is the power cord connected properly?

Check the power cord connection and supply.

Can you see "Check Signal Cable" on the screen?

(Connected using the D-sub cable)

Check the signal cable connection.

(Connected using the DVI cable)

If you still see an error message on the screen when the monitor is connected properly,

check to see if the monitor status is set to analog.

If you still see an (error) message on the screen when the monitor is connected properly,

check to see if the monitor status is set to analog. Press '

double-check the input signal source.

If the power is on, reboot the computer to see the initial screen (the login screen), which

can be seen.

If the initial screen (the login screen) appears, boot the computer in the applicable mode

(the safe mode for Windows ME/XP/2000) and then change the frequency of the video

card.

(Refer to the Preset Timing Modes)

If the initial screen (the login screen) does not appear, contact the Service Center or

your dealer.

Can you see "Not Optimum Mode", "Recommended Mode 1680 x 1050 60 Hz" on

the screen?

Troubleshooting

' button to have the monitor