Siemens HX9R3AE50 Podręcznik użytkownika - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Piekarnik Siemens HX9R3AE50. Siemens HX9R3AE50 44 stron.
Drukuj stronę
For the service department
Attention!
The device must be connected in accordance with
■
the specifications on the type plate.
Only connect the appliance to an electrical
■
connection that complies with the applicable
regulations. The socket must be easily accessible in
order to disconnect the appliance from the mains if
necessary.
An all-pole isolating device must be fitted.
■
Never use an extension cord or multiple plug.
■
For safety reasons, this device may only be
■
connected to an earth connection. If the protective
earth connection does not meet the requirements,
protection against electrical hazards is not
guaranteed.
A cable of type H 05 WF or equivalent must be used
■
to connect the device.
Place the stove horizontally with the
spirit level
Place the stove directly on the floor.
Pull out the oven drawer and lift it up. At the
1.
bottom are inside front and rear adjustable feet.
If necessary, turn the adjustable feet up or down with
2.
a hex wrench until the cooker is level (Figure A).
Push the oven drawer back in (Figure B).
3.
Adjoining furniture
Adjacent furniture should be made of non-
combustible material. Adjacent furniture fronts
should be heated to at least 90°C
to be temperature resistant.
Wall mounting
To prevent the cooker from tipping over, fix it to the wall
with the hook supplied. Observe the installation
instructions for wall mounting.
Placing the device
The appliance should be placed according to the
■
specified dimensions and directly on the floor
surface of your kitchen. The device should not be
placed on top of any object.
For the distance between the top of the cooker and
■
the bottom of the hood, follow the hood
manufacturer's instructions.
Make sure that the device is not moved after
■
installation. The distance between the extra powerful
burner or wok burner and adjacent kitchen furniture
or the wall must be at least 50 mm.
:
Warning – Risk of a gas leak!
The device must not be moved after installation.
When moving the unit after installation, check the
connection for leakage.
Measures during transport
Fix all movable parts in and on the device with adhesive
tape, which can be removed without leaving a trace.
Slide all accessories (e.g. the baking tray) into the
compartments with a thin strip of cardboard on both
sides to prevent damage to the appliance. Place
cardboard or the like between the front of the baking
tray and the back of the door to prevent the baking tray
from hitting the inside of the glass door. Attach the door
and, if present, the top cover to the sides of the
appliance with adhesive tape.
Keep the original packaging of the device. Only
transport the device in its original packaging. Note the
transport arrows on the packaging.
If the original packaging is no longer available
Pack the device in protective packaging to ensure
adequate protection against possible transport damage.
Transport the device upright. Do not hold the appliance
by the door handle or connections on the back, as this
could damage them. Do not place heavy objects on the
device.
Place and connect
NL
11