Siemens WM10K210ME Instrukcja obsługi i instrukcja instalacji - Strona 37
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Spryskiwacz Siemens WM10K210ME. Siemens WM10K210ME 40 stron.
Drukuj stronę
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
Notes
The washing machine
■
correctly installed
From ~ Page 32
Never use a damaged machine.
■
Inform your after-sales service.
Check the machine.
1.
Remove the protective film from the
2.
control panel.
any laundry.
must be
and
.
connected
Positioning and connecting
Connect the mains plug.
3.
Turn on the water tap.
4.
Close the washing machine door (do
5.
not load any laundry).
Select thei
6.
Cottons
and set the temperature to
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
8.
compartment
Pour standard detergent into
9.
compartment
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
Close the detergent drawer.
10.
Press
.
11.
Start
Switch off the appliance at the end of
12.
the programme.
Your washing machine is now ready to
use.
programme
90 °C
.
II
.
II
en
.
37