Siemens WM12W520IL Instrukcja obsługi i instrukcja instalacji - Strona 34
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Spryskiwacz Siemens WM12W520IL. Siemens WM12W520IL 48 stron.
Drukuj stronę
Faults and what to do about them.
en
Faults and what to do about them.
Faults
Water is leaking from the
machine.
The machine is not filling
with water.
Detergent is not being dis-
pensed.
The door cannot be
opened.
The programme will not
start.
The drum briefly jerks or
judders after the pro-
gramme has started.
The water is not draining.
Water is not visible in the
drum.
The spin result is not sat-
isfactory.
Laundry is wet/too damp.
The spin cycle runs sev-
eral times.
The programme is taking
longer than usual.
The length of the pro-
gramme changes during
the wash cycle.
Residual water in the
care-product compart-
ment i .
34
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
Have you pressed the Ü button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter. ~ Page 31
■
Is the supply hose kinked or trapped?
■
The safety function is activated. Stop the programme? ~ Page 25
■
Is the w childproof lock activated? Deactivate it. ~ Page 25
■
Is $ selected (Rinse Stop = no final spin)? ~ Page 25
■
Can the door only be opened by the emergency release? ~ Page 32
■
Have you pressed the Ü button or selected Finish in 5 time?
■
Is the door closed?
■
Is the w childproof lock activated? Deactivate it. ~ Page 25
■
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
Is $ selected (Rinse Stop = no final spin)? ~ Page 25
■
Clean the drain pump. ~ Page 30
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Is Less ironing æ selected (depending on the model)? ~ Page 21
■
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbalance.
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system is active – a rinse cycle has been
■
switched on.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the display
panel.
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
■