Siemens SC73E610TI Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Siemens SC73E610TI. Siemens SC73E610TI 40 stron.

Drukuj stronę

Rinse aid

1. Open the dispenser 1Z by pressing

and lifting the plate on the cover.

2. Carefully pour rinse aid up

to the max. mark in the filler opening.

3. Close cover until it clicks shut.

4. To prevent excessive foam formation

during the next rinse cycle, remove

any rinse aid which has run over with

a cloth.

Setting amount of rinse aid

The amount of rinse aid dispensed can

be set from :

the amount of rinse aid to be dispensed

to :

to obtain a very good drying

result. The the factory setting is :

Do not change the amount of rinse aid

unless streaks (select lower setting)

or water stains (select higher setting)

are left on the utensils.

1. Close the door.

2. Switch on ON/OFF switch (.

3. Press and hold down the START

button 8.

4. Rotate programme selector 0

until : ... is indicated on the digital

display @.

5. Release button.

The factory-set value :

is lit on the digital display @.

To change the setting:

1. Rotate programme selector 0 until

the required value is indicated on the

digital display @.

2. Press START button 8.

The set value is saved.

Switching off rinse aid refill

indicator

If the rinse-aid refill indicator X is

impaired (e.g. when using combined

detergents containing rinse aid

component), it can be switched off.

Proceed as described under "Setting

amount of rinse aid" and set the

value to :

The rinse aid refill indicator X is now

switched off.

to :

. Set