Siemens EC7A5RB90A Instrukcje użytkownika - Strona 11
Przeglądaj online lub pobierz pdf Instrukcje użytkownika dla Hob Siemens EC7A5RB90A. Siemens EC7A5RB90A 20 stron.
Drukuj stronę
--------
Code
HZ233540 Additional wok grid: Cast iron (4-5 kW)
HZ233440 Additional wok grid: Cast iron (mini wok
burner)
HZ241110 Additional espresso maker grid
HZ298105 Simmer Plate
HZ211310 Simmer cap
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
ÄGas burners
S witching on manually
G a s b u r n e r s
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power setting.
Hold an igniter or a naked flame (such as a lighter or
2.
a match) against the burner.
Automatic ignition
If the hob has automatic ignition (ignition plugs):
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power level.
While the control knob is held down, all the burners
will generate sparks. The flame ignites. Wait a few
seconds.
Release the control knob.
2.
Turn the control knob to the required position.
3.
If the burner does not ignite, switch it off and repeat the
steps described above. This time, hold the control knob
down for longer (up to 10 seconds).
Simmer plate
This accessory part is only suita-
ble for simmering. It can be
used with the economy burner
or the standard-output burner. If
your hob has several standard-
output burners, we recommend
placing the simmer plate on the
rear or front-right standard-out-
put burner.
Place the accessory component
with the projections facing
upwards on the holder; never
place it directly on the burner.
Simmer cap
Only use the cap for cooking
with minimal power. Place the
simmer cap on the cover of the
economy burner. Always place
cookware on the pan support,
never directly on the simmer
cap.
:
Warning – Risk of deflagration!
If the flame does not ignite after 15 seconds, switch off
the burner and open a window or the door to the room.
Wait at least one minute before switching the burner on
again.
It is important to keep the appliance clean. If the
Note:
ignition plugs are dirty, this may cause ignition
problems. Clean the ignition plugs regularly with a
small, non-metallic brush. Take care to prevent the
ignition plugs from suffering any heavy knocks.
Safety system
Your hob is equipped with a safety system
(thermocouple) that cuts off the gas when the burners
are accidentally switched off.
To ensure that this device is active:
Switch on the burner as usual.
1.
Without releasing the control knob, press and hold it
2.
down firmly for 4 seconds after lighting the flame.
Switching off a burner
Turn the corresponding control knob clockwise to the 0
setting.
A few seconds after the burner is switched off, a sound
(thud) will be produced. This is not a fault - this means
that the safety device is no longer operating.
Warnings
It is normal to hear a soft whistling noise while the
burner is operating.
When first used, it is normal for the burner to give off
odours. This does not pose any risk and does not
indicate a malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by
the presence of dust in the atmosphere, spilt liquids,
etc.
In the event of the burner flames being accidentally
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least one minute.
Gas burners
en
11