Siemens EH BE15 Series Podręcznik użytkownika - Strona 21
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Hob Siemens EH BE15 Series. Siemens EH BE15 Series 28 stron. Induction hob with integrated ventilation system
Również dla Siemens EH BE15 Series: Informacje dotyczące użytkowania (24 strony)
Drukuj stronę
18.4 Cleaning
Question
How can I clean the hob?
There is water in the cab-
inet underneath the hob.
How often do I need to
clean the overflow con-
tainer?
How often do I need to
clean the grease filter?
19
Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
19.1 Information on the display panel
Fault
No displays light up.
The displays flash.
The "-" display flashes in the
cooking zone displays.
Answer
¡ You can achieve the best results by using special glass-ceramic cleaning
products. Do not use harsh or abrasive cleaning products, dishwater detergent
(concentrated) or scouring pads.
You can find more information about this under
→ "Cleaning and servicing", Page 17.
¡ Check whether the overflow container is full.
You can find further information about cleaning and caring for the hob under
→ "Cleaning and servicing", Page 17.
¡ Clean the overflow container frequently.
You can find further information about how to clean the overflow container under
→ "Cleaning and servicing", Page 17.
¡ Regularly clean the grease filter.
To find out how to clean and replace the filter, refer to the section entitled
→ "Cleaning and servicing", Page 17.
Cause & Troubleshooting
The power supply has been disconnected.
Use other electrical appliances to check whether there has been a power fail-
▶
ure.
The appliance has not been connected as shown in the circuit diagram.
Connect the appliance in accordance with the circuit diagram.
▶
Electronics fault
If you are unable to rectify the fault, inform the technical after-sales service.
▶
The control panel is wet or an object is covering it.
Dry the control panel or remove the object.
▶
A fault has occurred in the electronics.
To acknowledge the fault, briefly cover the control panel with your hand.
▶
The odour filter is saturated or the saturation indicator lights up even though the
filter has been replaced.
Change the filter and reset the filter saturation indicator. You can find addi-
▶
tional information about this in the section entitled
→ "Cleaning and servicing", Page 17.
The electronics have overheated and have switched off the affected cooking
zone.
Wait until the electronics have cooled down sufficiently. Then touch any sym-
▶
bol on the hob.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
Troubleshooting en
21