Siemens EH8..TC1.. Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Hob Siemens EH8..TC1... Siemens EH8..TC1.. 16 stron.
Również dla Siemens EH8..TC1..: Instrukcja obsługi (16 strony)

Siemens EH8..TC1.. Instrukcja obsługi

Accessing the basic settings

The hotplate must be off.
Switch on the hob.
1.
In the following 10 seconds, press the
2.
for 4 seconds.
™‚
appears on the left side of the screen, and

Care and cleaning

The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition

Hob

Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
Abrasive products
heavy-duty cleaners, like oven sprays and stain removers
Pads that may scratch
High-pressure or steam cleaners
Glass scraper
Remove dried-on food remains using a glass scraper.

Fixing malfunctions

Malfunctions are generally caused by minor faults. Before
contacting the Technical Assistance Service, make sure you
have read the following recommendations and warnings.
Indicator
Malfunction
none
The electric power supply has been inter-
rupted.
The appliance has not been correctly con-
nected following the connection diagram.
Electronic system malfunction.
* If the warning persists call the Technical Assistance Service.
Do not place hot pans on the control panel.
symbol and hold it
@
on the right.
Measure
Use other electrical appliances to check if there has been a power
cut.
Make sure that the appliance has been connected correctly.
If in the above checks, the malfunction is not resolved, contact the
Technical Assistance Service.
Press the
@
symbol several times until the required
3.
function appears.
Then select the required setting using the + and - symbols.
4.
Press the
@
symbol again and hold it for more than 4
5.
seconds.
The settings will have been correctly stored.
Quit
To leave the basic settings, turn off the hob at the main switch.
Release the scraper safety catch
1.
Use the blade to clean the hob surface
2.
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
Risk of injury!!
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.

Hob frame

In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
Do not use sharp or abrasive products
Do not use a glass scraper
11