Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Skrócona instrukcja obsługi - Strona 29
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Projektor Epson C11CA19201 - WorkForce 30 Color Inkjet Printer. Epson C11CA19201 - WorkForce 30 Color Inkjet Printer 36 stron. Color inkjet printer
Również dla Epson C11CA19201 - WorkForce 30 Color Inkjet Printer: Arkusz specyfikacji (3 strony), Skrócona instrukcja obsługi (9 strony), Specyfikacje (2 strony)
Drukuj stronę
Notices
Important Safety Instructions
Before using your WorkForce 30 Series printer, read and follow these safety instructions:
■
Be sure to follow all warnings and instructions marked on the printer.
■
Use only the type of power source indicated on the printer label.
■
Use only the power cord that comes with the printer. Use of another cord may cause
fires or shock. Do not use the cord with any other equipment.
■
Place the printer near a wall outlet where the plug can be easily unplugged.
■
Avoid plugging the printer into an outlet on the same circuit as a photo copier or air
control system that regularly switches on and off, or on an outlet controlled by a wall
switch or timer.
■
Do not let the power cord become damaged or frayed.
■
If you use an extension cord with the printer, make sure the total ampere rating of the
devices plugged into the extension cord does not exceed the cord's ampere rating.
Also, make sure the total ampere rating of all devices plugged into the wall outlet does
not exceed the wall outlet's ampere rating.
■
Avoid locations that are subject to rapid changes in heat or humidity, shocks or
vibrations, or dust.
■
Leave enough room around the printer for sufficient ventilation. Do not block or
cover openings in the printer case or insert objects through the slots.
■
Do not place the printer near a radiator or heating vent or in direct sunlight.
■
Place the printer on a flat, stable surface that extends beyond its base in all directions.
It will not operate properly if it is tilted or at an angle.
■
Make sure the back of the printer is at least 4 inches (10 cm) away from the wall.
■
Do not spill liquid on the printer.
■
Except as specifically explained in your documentation, do not attempt to service the
printer yourself.
■
Unplug the printer and refer servicing to qualified service personnel under the
following conditions: if the power cord or plug is damaged; if liquid has entered the
product; if the product has been dropped or the case damaged; if the product does not
operate normally or exhibits a distinct change in performance. Adjust only those
controls that are covered by the operating instructions.
29
Notices