Cisco 8831 Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Telefon IP Cisco 8831. Cisco 8831 14 stron. Hard factory reset
Również dla Cisco 8831: Cechy (17 strony), Podręcznik wdrażania (6 strony), Skrócona instrukcja obsługi (2 strony), Podręcznik użytkownika (6 strony), Skrócona instrukcja obsługi (6 strony), Podręcznik użytkownika (15 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (13 strony), Instrukcja rozwiązywania problemów (3 strony)

Cisco Unified IP Conference Phone 8831 Installation

Set Wireless Microphone Region

Procedure

Step 1

In Cisco Unified Communications Manager Administration, go to Device > Phone.

Step 2

Use the Find capability to find the Cisco Unified IP Conference Phone 8831.

Step 3

In the Product Specific Configuration Layout area of the Phone Configuration window, change the Wireless

Microphone Region setting to the region where the device is located. The drop-down list box lists the available

regions.

Safety

Review the following warnings before installing the conference station. To see translations of these warnings,

see the Regulatory Compliance and Safety Information for Cisco Unified IP Conference Stations document

that accompanied this device.

Read the installation instructions before you connect the system to its power source.

Attention

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Attention

Ultimate disposal of this product should be handled according to all national laws and regulations.

Attention

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Attention

To avoid electric shock, do not connect safety extra low voltage (SELV) circuits to teleconference station

Caution

network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits.

Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.

The following warnings apply when you use an external power supply.

This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that a

Attention

fuse or circuit breaker no larger than 120 VAC, 15 A U.S. (240 VAC, 10 A international) is used on the

phase conductors (all current-carrying conductors

Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0

Safety