Machine Run-up and Installation Requirements
The following items are required to run up and install the Pro C900/ Pro
C900s mainframe:
Qty Item
6
Silicon Oil
Type SS
A257 9550
1
Mainframe
32 Amp
single
phase male
plug
1
Trained
Customer
Replaceable
Units
(TCRU) Kit
1
Customer
Replaceable
Units (CRU)
1
Field
Replaceable
Unit (FRU)
1
Silicon Oil
Catcher
Tray
4
100gsm A4
non coated
2
100gsm A3
non-coated
1
64mb
Machine SD
Card
1
19mm
Yellow
Tongue
Flooring
Colour High Volume Production System - Installation Guide
Pro C900
Notes
Three bottles of silicon oil for the machine (when on-site) and three
bottles for the customer. The Pro C900 / Pro C900s models are
shipped with enough silicon oil in the oil tank to complete the
workshop run-up procedure.
Two types of plugs are recommended. The type of plug that needs to
be purchased will depend on the customer's 32 amp female socket
location and type:
Clipsal Product Number 56PA332, 3 Round Pins, Angled Plug
Clipsal Product Number 56P332, 3 Round Pins, Straight.
This kit will be delivered with every order. Ideally the TCRU items will
remain at the customer's site.
Toner, finishing consumables, waste toner bottle (G178 6973). These
items will remain at the customer's office.
Fusing unit (G178 4142). This item will remain at the customer's
office.
This tray will be required for the FRU fusing unit. The silicon oil
Catcher Tray is not available as a spare part. Please source a local
solution.
Four reams of 100gsm A4 non-coated paper
Two reams of 100gsm A3 non-coated paper.
NVRAM data, address book data and Fiery settings back-up. At
installation all address book information, NVRAM data and Fiery
settings will be backed up to an SD card. This item will remain at the
customer's office.
When flooring is required, Yellow Tongue flooring is the
recommended flooring type. It comes in various shapes and sizes.
Chosen sizes will need to suit the machine and finishing option
configuration so that the join between each floor board does not
coincide with the wheels of the mainframe or finishing option.
Please refer to the Production Range Dimension Calculator xls file to
determine flooring dimensions.
This calculator can be downloaded from the Technical Website/
Documents/ Pro C900 - Pro C900s / Installation Documents section.
Please use the following link;
http://partners.ricoh.com.au/web/aubase/technical/documents.nsf/
allbymodel/B1EF3252E8A986B8CA2575D00080D6C3?OpenDocument
Page 5 of 24
Drukuj stronę