Ricoh 126C-FLEX TLS Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Aparat cyfrowy Ricoh 126C-FLEX TLS. Ricoh 126C-FLEX TLS 7 stron.

Do not open camera back until all pictures have been taken and paper backing has been wound past Film

Window.

Correct exposure

When the amount of light is not proper, i.e. too much or too little, a

signal will appear at the left bottom corner in the View Finder, and the Shutter

Release Button is automatically locked, thus preventing improper exposure. Then

choose a different shutter speed, or use flash. (See page 5 for flash pictures). This Red

Warning Signal device does not function when Auto/Manual Ring is set to the manual

aperture position for intentional under- or over-exposed photography. The Through-

The-Lens CdS exposure meter works on a 1.3 volt "mercury battery" (Mallory

RM675 or equivalent) and it will last for approximately one year. When inserting the

battery, make sure that (+) and ( - ) ends of the battery are facing the direction

illustrated in the Battery

Housing (O) (Fig. 5).

Simply turn Shutter Speed Ring (D) until

the desired shutter speed number is set at

the red mark (Fig. 2). Be certain the Ring is

set at a click stop. "60" (1/60-second) is

recommended for subject not in motion.

Where motion exists, the faster shutter,

1/125 or 1/300,should be used. When set at

"B", the shutter will remain open as long as

the Shutter Release Button (A) is depressed.

For automatic Turn the Auto/Manual

Ring (B) until "A" comes at the black

marker (Fig. 3), And the Through-The-

Lens CdS exposure meter

automatically sets the f-stop always to

obtain correct amount of light. The f-

stop number at which your picture is

taken is shown in Exposure Meter

Window (L) on top of camera (Fig. 4).

Red

warning