Cisco Webex 860 Konfiguracja - Strona 9

Przeglądaj online lub pobierz pdf Konfiguracja dla Telefon IP Cisco Webex 860. Cisco Webex 860 10 stron.
Również dla Cisco Webex 860: Skrócona instrukcja obsługi (3 strony), Instrukcja rozwiązywania problemów (6 strony), Podręcznik (12 strony), Podręcznik (36 strony), Skrócona instrukcja obsługi (3 strony)

Phone Setup

Step 8

Tap Connect.

Add the Phone to a Nonbroadcast Wi-Fi Network

Follow these steps to add your phone to a Wi-Fi network that is hidden or not broadcast.

Before you begin

You need the following information about the Wi-Fi network:

• Network name or Service Set Identifier (SSID)

• Network security mode (None, PSK, EAP-TLS, EAP-TTLS, or PEAP)

• PIN or passkey for the security mode, if you use one

Procedure

Step 1

Swipe up from the bottom of the phone's display to show the installed applications.

Step 2

Tap the Settings

Step 3

Select Network & internet > Wi-Fi.

Step 4

Tap Add Network.

Step 5

Enter the desired Wi-Fi Network name.

Step 6

Select the desired Security:

• For an open network, select None.

• For a PSK enabled Wi-Fi network, select WPA/WPA2- Personal and enter the enter the 8-63 ASCII or

• For an EAP enabled Wi-Fi network, select WPA/WPA2-Enterprise.

Step 7

For an EAP-TLS, EAP-TTLS, or PEAP network, select the network EAP method: PEAP, TLS, or TTLS.

Step 8

For a network with an EAP-TLS security mode, select the desired CA certificate and User certificate.

Check with your administrator for the certificate type to select and also arrange to install the certificates on

your phone.

Step 9

For a network with an EAP-TTLS or PEAP security mode, select the Phase 2 authentication method and

CA certificate option to use, and then enter the Identity and Password.

Step 10

Under Advanced options, set Hidden network to Yes.

You can also set the Proxy and IP settings as required.

Step 11

Tap Save.

app.

64 HEX Password.

Add the Phone to a Nonbroadcast Wi-Fi Network

Phone Setup