Epson EMP 30 - PowerLite 50c XGA LCD Projector Szybka konfiguracja - Strona 2
Przeglądaj online lub pobierz pdf Szybka konfiguracja dla Projektor Epson EMP 30 - PowerLite 50c XGA LCD Projector. Epson EMP 30 - PowerLite 50c XGA LCD Projector 2 stron. Epson powerlite 70c: quick start
Również dla Epson EMP 30 - PowerLite 50c XGA LCD Projector: Specyfikacje (2 strony), Informacje o produkcie (13 strony)
Drukuj stronę
Adjust the image
Remove the lens cap and rotate the focus ring
1
to sharpen the image.
If you see a blank screen
Note:
see the box below.
If you see a blank screen or the No Signal message
after turning on your laptop, check the following:
Make sure the
power light is green and
not flashing and the lens cap is off.
Try turning off the laptop and restarting it.
If you've connected more than one computer and/or video source,
you may need to press the Source button on top of the projector.
(Allow a few seconds for the projector to sync up after pressing it.)
If you're using a Windows laptop:
Press the function key that lets you display on an external monitor.
It may have an icon such as
You may have to hold down the Fn (function) key while pressing it.
(Allow a few seconds for the projector to sync up after pressing
the key.) Check your laptop's manual or online help for details.
On most systems, the
the LCD screen and the projector, or display on both at the same
time.
You might need to use the Display utility in the Control Panel
to enable both the LCD screen and external monitor port.
EPSON PowerLite 50c/70c
EPSON is a registered trademark of SEIKO EPSON CORPORATION. PowerLite is a registered trademark of Epson America, Inc.
Copyright © 2001 by Epson America, Inc. 1/01
focus ring
after focusing,
No signal
If You See a Blank Screen
No signal
, or it may be labelled CRT/LCD.
or CRT/LCD key let you toggle between
EPSON PowerLite 50c/70c
2
Raise the image as needed. To do this, pull up the blue foot
release levers and lift the front of the projector. Once the
image is positioned where you want it, release the levers
to lock the feet in position.
3
If your image looks like
at an angle to the screen. Move it directly in front of the
center of the screen, facing the screen squarely.
If your image looks like
4
the Keystone button to correct the shape of the image.
If you're using a Macintosh
1. From the Apple menu, select Control Panels, then click Monitors
and Sound.
2. Click the Arrange icon.
click here
3. Drag one monitor icon on top of the other. This lets you display
on the projector screen as well as the LCD screen.
If this option isn't available, you may need to select one of the
Simulscan resolution settings:
1. Perform step 1 above, if necessary.
2. Click the Monitor icon.
click here
3. Select a Simulscan resolution as shown. (Allow a few seconds for
the projector to sync up after making the selection.)
or
, you've placed the projector
or
, press the + or – side of
®
:
drag one monitor icon
on top of the other
select a Simulscan
resolution
CPD-11579