Cisco 10008 Skrócona instrukcja obsługi - Strona 38

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Router sieciowy Cisco 10008. Cisco 10008 49 stron. Cisco systems router quick start guide

Drukuj stronę

After you respond to the SNMP questions, the setup script lists the interfaces., for example:

Interface

Ethernet0/0/0

FastEthernet0/0/0

Interfaces that are not okay (OK? = NO) do not have a valid configuration.

Step 10 To achieve network connectivity, enter the interface for the Fast Ethernet interface.

Enter interface name used to connect to the management network from the above interface summary:

FastEthernet0/0/0

Step 11 Accept the default value for the type of connector. RJ-45 is the only connector that can be used on the Cisco 10008

router Ethernet port.

Configuring interface FastEthernet0/0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Step 12 Configure both the Cisco 10008 router and the remote device to use the same mode.

Operate in full-duplex mode? [no]: no

Step 13 You must enter the IP address to achieve network connectivity.

Configure IP on this interface? [yes]: yes

Step 14 Specify the IP address.

IP address for this interface: 172.27.48.209

Step 15 Enter the subnet mask for the IP address.

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

The system displays the information you entered as well as several default commands, such as the no shutdown command; for

example:

The following configuration command script was created:

hostname c10008

enable secret 5 $1$uror$EFU0hKOBQXhk975qKFZlL0

enable password lab

line vty 0 4

password lab

no snmp-server

no ip routing

interface FastEthernet0/0/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.27.48.209 255.255.0.0

end

Step 16 The setup script concludes by giving you the choice to exit without saving, start the setup script, or save the

configuration file:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]:

IP-Address

OK?

unassigned

YES

unassigned

Method

Status

unset

Protocol