Cisco 12016 Instrukcja wymiany - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Router sieciowy Cisco 12016. Cisco 12016 32 stron. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router
Również dla Cisco 12016: Instrukcja rozpakowywania Podręcznik (28 strony), Arkusz danych (9 strony), Instrukcja obsługi (16 strony), Instrukcja wymiany (18 strony)

Drukuj stronę

Chassis Card Cages

The router has three integral card cages: the upper card cage, the lower card cage, and the switch fabric

card cage. (See

The upper card cage has eight user-configurable slots that support a combination of line cards and a route

processor (RP). The far left slot in the upper card cage is a dedicated slot for a pre-installed alarm card.

The far right slot (slot 7) in the upper card cage is reserved for the RP. The remainder of the slots in the

upper card cage (slots 0 through 6) can be populated with any of the line cards supported by the router.

The lower card cage also has eight user-configurable slots that support more line cards and an optional,

redundant RP. The lower card cage is an inverted, or head-down, copy of the upper card cage, meaning

that cards are installed the same way they are installed in the upper card cage, but in an inverted or

head-down orientation. The far right slot in the lower card cage is dedicated to a second alarm card,

followed by slots 8 through 15 moving right to left.

Note

If the router is equipped with an optional, redundant RP, it must be installed in the far left slot of the

lower card cage (slot 8). If the router is not equipped with an optional, redundant RP, a line card can be

installed in slot 8 of the lower card cage.

The switch fabric card cage has five slots for the cards that contain the switch fabric circuitry. These

cards are the clock and scheduler cards (CSCs) and the switch fabric cards (SFCs). The card slots in the

switch fabric card cage are keyed to accept specific card types. The two far left slots (labeled CSC0 and

CSC1) accept CSCs; the three far right slots (labeled SFC1, SFC2, and SFC3) accept SFCs.

All line card slots must be filled at all times to maintain proper chassis card cage alignment; blank filler

Caution

line cards are available for this purpose as necessary. Installed line cards remain in their slots except

during replacement.

Chassis Backplane

The three card cages are tied together electrically through a passive system backplane in the back of the

chassis. Nearly all the wiring in the router is contained within or connected to the chassis backplane. The

chassis backplane distributes DC power to all the cards and blower modules in the router and provides

the physical communication pathway between cards, both for network data and system communication

across the internal system maintenance bus (MBus).

Cooling

The two removable blower modules at the top and bottom of the chassis (see

cooling air for all cards in the three card cages. In the power shelf, each power module contains a fan

that draws cooler air into the front of the power module and forces warmed air out the back of the power

shelf.

Power

The router can be ordered with the AC-input power subsystem with three AC-input power supplies, or

the DC-input power subsystem with four DC-input power entry modules (PEMs).

78-16082-01

Figure

1.)

Cisco 12016, Cisco 12416, and Cisco 12816 Router Chassis Replacement Instructions

Chassis Overview

Figure 1 on page

2) provide