Cisco 1921 Instalacja i aktualizacja - Strona 20

Przeglądaj online lub pobierz pdf Instalacja i aktualizacja dla Router sieciowy Cisco 1921. Cisco 1921 24 stron. 1900 series

Modules Internal to the Cisco 1941 Router

Figure 18

Note

Replace the cover. See

Step 12

Note

Installing a Blower

To replace a blower, perform the following procedure. To complete this procedure, you need a number 2

Phillips screwdriver or flat-blade screwdriver.

Remove the cover. See

Step 1

Locate the blower in the chassis. See the

Step 2

blower.

Remove the three screws from the blower as shown in

Step 3

Lift the blower from the chassis and disconnect the power cable.

Step 4

Insert the replacement blower.

Step 5

Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs

Installing the AC Cable

The AC cable should thread through the sheet metal channel on top of the PoE cable as shown

Figure

18.

"Opening and Closing the Chassis" section on page

If your Cisco 1941 ISR is wireless, reattach the wireless antennas.

"Opening and Closing the Chassis" section on page

Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs

"Locating Modules" section on page 7

Figure

12.

for the location of the