Cisco 2500 Series Podręcznik wdrażania - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik wdrażania dla Router sieciowy Cisco 2500 Series. Cisco 2500 Series 23 stron. Wireless controller
Również dla Cisco 2500 Series: Instrukcja instalacji (12 strony), Podręcznik konfiguracji (19 strony), Podręcznik konfiguracji (50 strony), Podręcznik dla początkujących (47 strony)

Drukuj stronę

Configure the Neighbor Switch

By default, all four ports on the Cisco 2500 Series Wireless Controller are 802.1Q trunk ports. The controller

is always connected to a Gigabit Ethernet port on the neighboring switch. The neighbor switch port is

configured as an 802.1Q trunk and only the appropriate VLANs are allowed on the trunk. All other VLANs

are pruned. This is not necessary, but is a deployment best practice because by pruning irrelevant VLANs, the

controller only processes relevant frames, optimizing performance.

This is the 802.1Q switchport configuration:

switchport

switchport trunk encapsulation dot1q

switchport trunk native vlan X

switchport trunk allowed vlan X

switchport mode trunk

end

Configure the Cisco 2500 Series Wireless Controller

Configure the Controller Using the Startup Wizard

(Cisco Controller)

Welcome to the Cisco Wizard Configuration Tool

Use the '−' character to backup

Would you like to terminate autoinstall? [yes]: yes

AUTO−INSTALL: process terminated −− no configuration loaded

System Name [Cisco_d9:24:44] (31 characters max): Szabla

Enter Administrative User Name (24 characters max): cisco

Enter Administrative Password (3 to 24 characters): ********

Re−enter Administrative Password

Management Interface IP Address: 10.10.10.20

Management Interface Netmask: 255.255.255.0

Management Interface Default Router: 10.10.10.1

Management Interface VLAN Identifier (0 = untagged): 0

Management Interface Port Num [1 to 4]: 1

Management Interface DHCP Server IP Address: 10.10.10.1

Virtual Gateway IP Address: 1.1.1.1

Mobility/RF Group Name: Jmobile

Network Name (SSID): Szabla

Configure DHCP Bridging Mode [yes][NO]: no

Allow Static IP Addresses [YES][no]: no

Configure a RADIUS Server now? [YES][no]: no

Warning! The default WLAN security policy requires a RADIUS server.

Please see documentation for more details.

Enter Country Code list (enter 'help' for a list of countries) [US]: US

Enable 802.11b Network [YES][no]: yes

Enable 802.11a Network [YES][no]: yes

Enable 802.11g Network [YES][no]: yes

Enable Auto−RF [YES][no]: yes

Configure a NTP server now? [YES][no]: no

Configure the system time now? [YES][no]: yes

Enter the date in MM/DD/YY format: 04/14/11

Enter the time in HH:MM:SS format: 15:52:20

Configuration correct? If yes, system will save it and reset. [yes][NO]: yes

: ********