Cisco 3800 Series Skrócona instrukcja obsługi - Strona 32

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Router sieciowy Cisco 3800 Series. Cisco 3800 Series 40 stron. Password recovery procedure
Również dla Cisco 3800 Series: Arkusz danych (8 strony), Nota aplikacyjna (41 strony), Instrukcja rozwiązywania problemów (15 strony), Arkusz danych (20 strony), Konfigurowanie (32 strony), Podręcznik użytkownika (7 strony)

Drukuj stronę

Cisco 3800 Series Skrócona instrukcja obsługi

entered, becomes encrypted in the configuration.

Enter enable secret: xxxxxx

Step 5

Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)

and can be seen when you view the configuration.

The enable password is used when you do not specify an

enable secret password, with some older software versions, and

some boot images.

Enter enable password: xxxxxx

Step 6

Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the

console port:

The virtual terminal password is used to protect

access to the router over a network interface.

Enter virtual terminal password: xxxxxx

Step 7

Respond to the following prompts as appropriate for your network:

Configure SNMP Network Management? [yes]:

Community string [public]:

A summary of the available interfaces appears.

Note

The interface numbering that appears is dependent on the type of Cisco modular router platform and on the

installed interface modules and cards.

Current interface summary

Controller Timeslots D-Channel Configurable modes Status

T1 0/0/0

T1 0/0/1

T1 0/2/0

T1 0/2/1

Any interface listed with OK? value "NO" does not have a valid configuration

Interface

GigabitEthernet0/0

GigabitEthernet0/1

Step 8

Choose one of the available interfaces for connecting the router to the management network:

Enter interface name used to connect to the

management network from the above interface summary: gigabitethernet0/0

Respond to the following prompts as appropriate for your network:

Step 9

Configuring interface GigabitEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: no

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 16 subnet bits; mask is /16

The configuration is displayed:

The following configuration command script was created:

hostname Router

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

pri/channelized

IP-Address

OK? Method Status

20.0.0.40

YES DHCP

unassigned

Administratively up

unset

Protocol