ACDC Dynamics FL-AC12 Instrukcje

Przeglądaj online lub pobierz pdf Instrukcje dla Czujniki bezpieczeństwa ACDC Dynamics FL-AC12. ACDC Dynamics FL-AC12 2 stron. Glass break detector

Drukuj stronę

GLASS BREAK DETECTOR

INSTRUCTION

FEATURE:

Double detecting method

SMD technology

Pulse width adjustable

Sensitivity adjustable

convenient mounting

MOUTING THE DETECTOR

1. SELECT LOCATION

Choose a location in front of the protected

glass area.

Make sure that the detector's field of view is

not blocked by any object.

Avoid installation in the following locations:

Areas with substantial air current.

Areas

with

high

audio

vibrations.

Detector's detection range may be

decreased in a place with acoustically

absorbing material.

2. MOUNTING

Determine mounting position and cable

routing.

Open the front cover by pressing the clip

located on the mid-right side with a

screwdriver, and pull it upward.

Run the cable along the cable-duct located

on the backside of the rear cover and insert

it through its prepared hole.

Mount the rear cover to the wall/corner as

determined previously.

Connect the wires to the terminal block

(according to the terminal block diagram.)

Close the detector case.

the terminal block located on the PCB.(like following

fig.)

replace the front cover until the closing click is

noise

heard.

Terminal output

Terminal 3&4

—

m arked "TAMPER"

If a tamper function is required, connect these

terminals to the control unit. When the front cover

of the detector is opened, an immediate alarm

signal will be sent to the

control unit.

Terminal 5&6

—

m arked "RELAY"

These are the output terminal contacts of the

detector.

Terminal 1

—

Connect to the negative polarity

Terminal 2

—

Connect to the positive polarity