C.T.M. HS-2750 Podręcznik użytkownika - Strona 16
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wózek inwalidzki C.T.M. HS-2750. C.T.M. HS-2750 20 stron.
HS-2750
Figure 22
OONAPU
Figure 23
Drive inhibit indication
Figure 24
Battery charging
Figure 25
OONAPU ("Out Of Neutral At Power Up") is a safety feature that
prevents accidental movement of the wheelchair, either when powering
up, or when the wheelchair comes out of an inhibit state.
If the LiNX LE System is turned on (or comes out of an inhibit state)
while the joystick is not in the centre position, an OONAPU warning
is displayed. During an OONAPU warning, the battery gauge LEDs
will flash continually to alert the user, and the chair will not drive.
If the joystick is returned to the centre position within five seconds,
the warning will clear and the wheelchair will drive normally.
However, if the joystick remains out of neutral for longer than five
seconds, an OONAPU error will occur; the error is displayed by the
Status indicator flashing red, and the chair will not drive. To clear
the error, return the joystick to the neutral position and power the
unit off and then on again.
Drive inhibit mode is indicated by the battery gauge with a right-to-left
chase sequence.
The chase sequence starts with the green LED on the right-hand
side, and one-by-one, each LED will switch on and then off. When
the sequence completes at the left-most red LED, it begins again
at the right-hand side.
The chase sequence continues until the error condition has been
cleared. (see section 6-1 for error indication)
Plug the battery charger into the Remote's XLR socket.
The Battery Gauge will indicate the system is being charged by
cycling between a left-to-right chase sequence, and then displaying
the approximate battery charge state at the end of the chase sequence.
Driving is prevented (inhibited) while the system is being charged.
Please see actual charging status as per LED light indicator of
charger. (see section 5-2)
14
User Manual