Cisco NCS 4216 Podręcznik - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik dla Router sieciowy Cisco NCS 4216. Cisco NCS 4216 23 stron.

Cisco NCS 4216 Features

The Cisco NCS 4216 includes the following specific components:

• Chassis —Seven rack unit in height while still maintaining a shallow depth and side-to-side air flow.

• Fan-tray with removable dust filter.

• New form factor and high performance RSP—This high performance RSP has aggregate switching

capacity of 480 Gbps in oversubscribed mode.

• The backplane and the RSP together have the provision to support higher density 10GE modules like

8x10GE and 100GE modules.

• Air flow baffle to allow a system to redirect air and allow front-to-back airflow for cooling.

• Flexible I/O configurations through 16 hot pluggable interface modules (single width). For example,

with NCS4216-RSP in oversubscribed mode:

• Metro ENET switching features along with TDM pseudo-wire support.

• Network processor provides flexibility to off-load control plane CPU processing for select OAM and

management packets (for example, CCM, BFD, LBM).

• Flexible ENET processing through table-driven packet processing engines.

• On-line insertion/removal (OIR) of all FRUs except GPS module, while the system is operational

• Power supply (2+1)—Support for DC power supply. Two PSUs should be powered-on at a time. If all

the three PSUs are powered on, they work in a load-sharing mode.

• Fully-redundant system with redundant combined control plane and data plane (excluding interfaces),

timing support, power supplies, and fans.

• Active and standby support of redundant control plane and data plane, and timing

• Intra-chassis IOS redundancy (requires both RSPs)

• Stateful-switchover between active and standby RSPs (for protocols supported by IOS).

• In-service software upgrade (ISSU) supported with same RSPs.

• Timing support for receipt and distribution of network frequency and time including SyncE, BITS,

1PPS/10MHz I/O, IEEE 1588-2008, and NTP.

• Support for ENET OAM.

• T1/E1 and T3/E3 line protection compliant with NEBS GR-1089.

• Patch Panel for the Interface Modules

Cisco NCS 4216 Hardware Installation Guide

◦ 16x10G + 2x100G + 80x1G

◦ 48x10G

◦ 48 T1/E1 TDM Interface Module (48XT1/E1)

◦ 48 T3/E3 TDM Interface Module (48XT3/E3)

◦ OC-192 Interface Module with 8-port Low Rate CEM Interface Module (10G HO / 10G LO)

Cisco NCS 4216 Overview