Cisco SGE2000 Podręcznik konfiguracji - Strona 36

Przeglądaj online lub pobierz pdf Podręcznik konfiguracji dla Router sieciowy Cisco SGE2000. Cisco SGE2000 46 stron. Nx-os fabric extender
Również dla Cisco SGE2000: Instrukcja szybkiej instalacji (32 strony), Uwaga dotycząca wydania (16 strony), Arkusz danych (5 strony), Instrukcja aktualizacji oprogramowania sprzętowego (5 strony), Skrócona instrukcja obsługi (2 strony)

Verifying the Configuration

b If disabled, enable TRILL style mac-address learning with the mac address-table core-port-learning

c In the VPC domain configuration mode, configure the emulated switch ID with the fabricpath switchid

d On each of the VPC/VPC+ peer link interfaces in interface configuration mode, enter the switchport

e On each VPC/VPC+ peer link port channel, enter the VPC peer-link command.

If you are changing an existing FEX VPC configuration to a FEX VPC+ configuration on an F Series

module, follow these steps:

a In the VPC domain configuration mode, enable partial DF mode with the fabricpath multicast

b If disabled, enable trill style mac-address learning with the mac address-table core-port-learning

c In the VPC domain configuration mode, configure the emulated switch ID with the fabricpath switchid

7 Copy the configuration.

switch(config)# copy running-config startup-config

switch(config)#

This section describes how to display the configuration of the Fabric Extender and verify the chassis hardware

status.

To display configuration information about the defined interfaces on a Fabric Extender, perform one of the

following tasks:

Command or Action

show fex [FEX-number] [detail]

show interface type number fex-intf

show interface fex-fabric

Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide

command.

<switchid#> command.

mode fabricpath command.

Configure the VPC ID with the vpc vpcid command.

load-balance command.

command.

<switchid#> command.

Configuring the Fabric Extender

Purpose

Displays information about a specific Fabric Extender

or all attached units.

Displays the Fabric Extender ports that are pinned to

a specific switch interface.

Displays the switch interfaces that have detected a

Fabric Extender uplink.

OL-25816-02