CAB ER4/210 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do drukarek CAB ER4/210. CAB ER4/210 14 stron. External rewinder
Również dla CAB ER4/210: Instrukcja obsługi (14 strony)

Drukuj stronę
CAB ER4/210 Instrukcja obsługi
12
5
Operation
5.2

Rewinding onto 40 mm (1.6 in) Cardboard Core

i
Notice!
Make sure that the spring (1) is mounted on the rewind axle (2)!
Consider that the cardboard core (3) should be about 1 mm (0.04 in) broader than the label strip
Warning!
!
Risk of injury by rotating engine parts.
When switching on the Rewinder starts immediately and winds to the material is tightened.
6
Figure 9
1
2
3
2 3
7
8
Rewinding onto 40 mm
(1.6 in) cardboard core
(drawing below without plate)
4
5
1. Put the cardboard core (3) on the rewind axle (2).
i
Notice!
Consider the required direction of rewinding :
- The broken line is valid for inside wound labels.
- The full line is valid for outside wound labels.
2. Feed the label strip over the guide axle (8) and under the
roller (7) up to the cardboard core (3).
3. Affix the end of the label strip with consideration of the
selected rewinding direction to the cardboard core using
adhesive tape or label.
4. Slide the plate (5) with the knurled screw outward onto the
rewind axle until it stops.
i
Notice!
When using small labels it is possible that the
cardboard core not covers the spring over the
whole length. In this case the groove on the plate
must be aligned so that it fits on the spring of the
rewind axle.
5. Tighten the knurled screw (4) on the plate.
6. Switch on the rewinder on the power switch.
12