Cisco XR 12416 Instrukcja przepakowywania - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja przepakowywania dla Router sieciowy Cisco XR 12416. Cisco XR 12416 26 stron. Cisco systems router owner's manual
Również dla Cisco XR 12416: Instrukcja instalacji (41 strony)

Drukuj stronę

Repackaging the Routers

Removing the Front Covers

Disconnecting RP Cables

Disconnecting Alarm Card Cables

Disconnecting Power Cables from the Power Shelf

Cisco XR 12416 and Cisco XR 12816 Router Chassis Installation Guide

A-8

Remove all of the front covers from the chassis as instructed in the

Chassis Front Covers" section on page

after it has been secured on the shipping pallet?

You must disconnect any cables that are connected to the RP console port,

auxiliary port, or either of the Ethernet ports, RJ-45 or MII. Identify each of the

RP cable connections and write them down on a piece of paper before you

disconnect the cables. After disconnecting the cables, remove them from the

chassis and place them safely aside.

Refer to the following descriptions in

information on RP cables:

GRP Console and Auxiliary Port Connection Guidelines, page 2-24

•

PRP Console and Auxiliary Port Connection Guidelines, page 2-27

•

GRP Ethernet Connection Equipment, page 2-29

•

PRP Ethernet Connection Equipment, page 2-36

•

You must disconnect any cable that is connected to the external alarm port on

either or both of the alarm cards. Identify the alarm cable connections and write

them down on a piece of paper before you disconnect the cables. After

disconnecting the cables, remove them from the chassis and place them safely

aside.

For information on alarm card cables, refer to the

Guidelines" section on page

If your router is equipped with either the standard or optional AC-input power

shelf, disconnect the AC-input power cords from their receptacles on the back

panel of the power shelf as instructed in the

Standard One-Level AC-Input Power Shelf" section on page

Appendix A

3-7. You will install them on the chassis

Chapter 2, "Preparing for Installation."

"Alarm Card Connection

2-33.

"Removing and Installing the

Repackaging the Router

"Removing the

for

5-32.

OL-17440-01