Cisco 500 Series Skrócona instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy Cisco 500 Series. Cisco 500 Series 25 stron. Stackable managed switches
Również dla Cisco 500 Series: Podręcznik z informacjami dotyczącymi bezpieczeństwa (42 strony), Podręcznik (4 strony), Quick Start Quide (13 strony), Skrócona instrukcja obsługi (21 strony), Arkusz danych (5 strony), Podręcznik użytkownika (4 strony), Podręcznik użytkownika (6 strony), Podręcznik użytkownika (46 strony), Podręcznik (40 strony), Podręcznik administracyjny (48 strony), Podręcznik (24 strony), Rozwiązywanie problemów i konserwacja (15 strony), Skrócona instrukcja obsługi (7 strony)

The default stack ports on the 500X are XG3/S1 and

XG4/S2. If the correct module is plugged into XG3/S1 and

XG4/S2, the switch should be able to detect the connection

and configure the speed according to the module capability

without any manual configuration. The 5G/S1 and 5G/S2

interfaces on the 500X need to be configured manually via

the CLI or web-based interface in order to utilize these ports

as stack ports.

The default stack ports on the 500 are S3 and S4. If the

correct module is plugged into S3 and S4, the switch should

able to detect the connection and configure the speed

according to the module capability without any manual

configuration. The S1 and S2 interfaces on the 500 need to be

configured manually via the CLI or web-based interface in

order to utilize these ports as stack ports.

The default stack ports on a switch function as regular Ethernet ports only

if you configure them to do so, or if the switch is configured to operate in

standalone mode. You cannot mix the stack speeds between the switches

or ports.

By default, SG500XG-8F8T is in standalone mode and has no stack

Any of the ports on the

port.

converted to a stack port. If you manually assign a Unit ID to one

unit, you should manually assign Unit IDs to all units. Using both

system-assigned and manually-assigned IDs in your network can

impact system performance.

Stack ports must be either configured with the same port

ARNING

speed or have the same speed capability on the module/cable

plug in. If the port speed is configured as auto, then the module

plugged into these two ports will need to have the same speed

capability, otherwise the switch will not be able to form as a

stack with multiple units.

A stack can have up to eight 500 series switches in it.

Switches in the same stack are connected together through their stack

ports. Depending on the type of stack ports and the desired speed, you

may need regular Cat5 or better Ethernet cables and/or Cisco approved

modules or cables for the 500 Series switches.

500 Series Stackable Managed Switches

SG500XG-8F8T switch can be