Cisco 800 Series Informacje o wersji - Strona 22

Przeglądaj online lub pobierz pdf Informacje o wersji dla Bezprzewodowy punkt dostępowy Cisco 800 Series. Cisco 800 Series 36 stron. Fast step software design guide
Również dla Cisco 800 Series: Skrócona instrukcja obsługi (13 strony), Skrócona instrukcja obsługi (17 strony), Konfigurowanie (32 strony), Podręcznik projektowania (50 strony)

Important Notes

ISDN NI1 Provisioning

If you have any problems with your ISDN NI1 provisioning, visit the Cisco ISDN Web site at

http://www.cisco.com/isdn.

NAT Support for H.323 Signaling

Currently, NAT does not support alerting H.225 messages. Therefore, NAT communication cannot be

established between the router end points. NAT support for H.323 signaling is limited to the Netmeeting

application.

Phone Mate Answering Machine Model 9200

A Phone Mate answering machine model 9200 fails to recognize the ringing signal sent by AMD R79

ringing SLIC. This was confirmed by testing against Phone Mate model 3750 and newer model 9300.

PPP over Frame Relay Support (RFC-1973)

Cisco 800 series routers do not support PPP protocol over Frame Relay.

TACACS+ with AAA

Cisco 800 series routers support the Terminal Access Controller Access Control System Plus

(TACACS+) protocol through Telnet. TACACS+ is a Cisco proprietary authentication protocol that

provides remote access authentication and related network security services, such as event logging. User

passwords are administered in a central database, rather than in individual routers. TACACS+ also

supports separate modular authentication, authorization, and accounting (AAA) facilities that are

configured at individual routers.

For information on how to configure TACACS+, refer to the "Configuring TACACS+" chapter in the

Security Configuration Guide. For information on TACACS+ commands, refer to the "TACACS,

Extended TACACS, and TACACS+ Commands" chapter in the Security Command Reference.

Cisco 800 series routers do not support the following protocols:

•

ROM Monitor set stop-bits Parameter

This release supports the setting of 1 only, for the ROM monitor set stop-bits parameter.

Release Notes for the Cisco 800 Series Routers for Cisco IOS Release 12.1(5)YC

TACACS, an older access protocol now deprecated by Cisco, or Extended TACACS, an extension

to the TACACS protocol.

RADIUS or Kerberos protocols.

78-12776-04