Cisco 800 Series Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy Cisco 800 Series. Cisco 800 Series 17 stron. Fast step software design guide
Również dla Cisco 800 Series: Informacje o wersji (36 strony), Skrócona instrukcja obsługi (13 strony), Konfigurowanie (32 strony), Podręcznik projektowania (50 strony)
Drukuj stronę
5
Connect the Cisco 800 Series Router to a PC
Follow these steps to connect the Cisco 800 series router to a PC:
Connect the yellow Ethernet cable from the yellow Ethernet port (Cisco 801 and 802 routers) or from the yellow
Step 1
Ethernet port with the number 0 (Cisco 803 and 804 routers) on the back panel of the router to the Ethernet port on
the NIC on the computer.
Figure 1
Connecting a Cisco 800 Series Router to a PC
HU B
NO HU B
C is c o 8
ET HE RN
0 3
ET 10 BA
SE T
CO NS OL
E
IS DN S/
T
0
1
2
3
Cisco 803 router
Verify that the HUB/NO HUB switch on the left side of the back panel has been set to the NO HUB position (out). If
Step 2
the button is in, press it to set it to the out position.
The HUB/NO HUB button corresponds to the Ethernet port on Cisco 801 and 802 routers and to Ethernet
Note
port 0 on Cisco 803 and 804 routers.
For Cisco 803 and 804 routers, connect additional computers to the Cisco 800 series router by connecting Ethernet
Step 3
cables from the Ethernet ports labeled with the numbers 1, 2, and 3 to the Ethernet ports on the computers.
Always connect the yellow cable or Ethernet cable that you supply to the yellow ports on the router. Do not connect
Caution
the cable to an ISDN S/T or U port or to a Network Termination 1 (NT1) device. Accidently connecting the cable
to the wrong port can damage your router.
4
PH ON E
1
2
PC