Cisco 800 Series Konfigurowanie - Strona 16

Przeglądaj online lub pobierz pdf Konfigurowanie dla Bezprzewodowy punkt dostępowy Cisco 800 Series. Cisco 800 Series 32 stron. Fast step software design guide
Również dla Cisco 800 Series: Informacje o wersji (36 strony), Skrócona instrukcja obsługi (13 strony), Skrócona instrukcja obsługi (17 strony), Podręcznik projektowania (50 strony)

Drukuj stronę

How to Configure Radio Settings on an Access Point

DETAILED STEPS

Command or Action

Step 1

enable

Example:

Router> enable

Step 2

configure terminal

Example:

Router# configure terminal

Step 3

interface dot11Radio interface

Example:

Router(config)# interface dot11Radio 0/3/0

Step 4

preamble-short

Example:

Router(config-if)# no preamble-short

Step 5

end

Example:

Router(config-if)# end

Step 6

copy running-config startup-config

Example:

Router# copy running-config startup-config

Configuring Transmit and Receive Antennas on an Access Point

Perform this task to select the antenna the AP uses to transmit and receive data.

SUMMARY STEPS

enable

configure terminal

interface dot11Radio interface

antenna {receive | transmit} {diversity | left | right}

end

copy running-config startup-config

Configuring Radio Settings on an Access Point

Purpose

Enables privileged EXEC mode.

Enter your password if prompted.

•

Enters global configuration mode.

Enters radio interface configuration mode.

The interface argument is in module/slot/port format,

•

except for the Cisco 800 series and Cisco 1800 series

fixed-configuration routers, where the interface

argument is either 0 or 1.

The 2.4-GHz radio is port 0, and the 5-GHz radio is

•

port 1.

Disables short preambles and enables long preambles.

Short preambles are enabled by default. Use the

•

preamble-short command to reenable short preambles

if they are disabled.

Returns to privileged EXEC mode.

(Optional) Saves your entries in the configuration file.