Cisco 800 Series Konfigurowanie - Strona 19

Przeglądaj online lub pobierz pdf Konfigurowanie dla Bezprzewodowy punkt dostępowy Cisco 800 Series. Cisco 800 Series 32 stron. Fast step software design guide
Również dla Cisco 800 Series: Informacje o wersji (36 strony), Skrócona instrukcja obsługi (13 strony), Skrócona instrukcja obsługi (17 strony), Podręcznik projektowania (50 strony)

Drukuj stronę

Configuring Radio Settings on an Access Point

DETAILED STEPS

Command or Action

Step 1

enable

Example:

Router> enable

Step 2

configure terminal

Example:

Router# configure terminal

Step 3

interface dot11Radio interface

Example:

Router(config)# interface dot11Radio 0/3/0

Step 4

no dot11 extension aironet

Example:

Router(config-if)# no dot11 extension aironet

Step 5

end

Example:

Router(config-if)# end

Step 6

copy running-config startup-config

Example:

Router# copy running-config startup-config

Configuring Ethernet Encapsulation Transformation Method on an Access Point

Perform this task to configure the encapsulation transformation method.

Encapsulation Types

When the AP receives data packets that are not 802.3 packets, the AP must format the packets to 802.3

using an encapsulation transformation method. These are the two transformation methods:

•

dot1h (802.1H)—This method provides optimum performance for Cisco Aironet wireless products.

RFC 1042—Use this setting to ensure interoperability with non-Cisco Aironet wireless equipment.

RFC 1042 does not provide the interoperability advantages of 802.1H but is used by other

manufacturers of wireless equipment. This is the default setting.

How to Configure Radio Settings on an Access Point

Purpose

Enables privileged EXEC mode.

Enter your password if prompted.

•

Enters global configuration mode.

Enters radio interface configuration mode.

The interface argument is in module/slot/port format,

•

except for the Cisco 800 series and Cisco 1800 series

fixed-configuration routers, where the interface

argument is either 0 or 1.

The 2.4-GHz radio is port 0, and the 5-GHz radio is

•

port 1.

Disables Aironet extensions.

Use the dot11 extension aironet command to enable

•

Aironet extensions if they are disabled.

Returns to privileged EXEC mode.

(Optional) Saves your entries in the configuration file.