Cisco 800 Series Konfigurowanie - Strona 4

Przeglądaj online lub pobierz pdf Konfigurowanie dla Bezprzewodowy punkt dostępowy Cisco 800 Series. Cisco 800 Series 32 stron. Fast step software design guide
Również dla Cisco 800 Series: Informacje o wersji (36 strony), Skrócona instrukcja obsługi (13 strony), Skrócona instrukcja obsługi (17 strony), Podręcznik projektowania (50 strony)

How to Configure Radio Settings on an Access Point

•

Configuring Universal Client Mode

Perform this task to configure universal client mode.

You can configure universal client mode on a Cisco ISR series router by setting the radio interface station

role to nonroot. This is different from configuring the dot11radio interface to operate in non-root bridge

mode, which requires specifying the word bridge at the end of the command, for example, station-role

non-root bridge.

In other Cisco wireless products such as the Cisco AP1232, the station-role non-root command

Note

operates the same as station-role non-root bridge command. On the ISRs, the two commands are

different: station-role non-root is considered the universal client mode and station-role non-root

bridge is considered the nonroot bridge mode.

SUMMARY STEPS

Configuring RTS Threshold and Retries on an Access Point, page 22

Configuring Maximum Data Retry on an Access Point, page 24

Configuring Packet Fragmentation Threshold on an Access Point, page 25

Configuring IP Phone Support on an Access Point, page 26

enable

configure terminal

interface dot11Radio interface

station-role {root [access-point | ap-only | bridge [wireless-clients]] | non-root [bridge]}

end

copy running-config startup-config

Configuring Radio Settings on an Access Point

(optional)