Cisco 800 Series Podręcznik projektowania - Strona 16

Przeglądaj online lub pobierz pdf Podręcznik projektowania dla Bezprzewodowy punkt dostępowy Cisco 800 Series. Cisco 800 Series 50 stron. Fast step software design guide
Również dla Cisco 800 Series: Informacje o wersji (36 strony), Skrócona instrukcja obsługi (13 strony), Skrócona instrukcja obsługi (17 strony), Konfigurowanie (32 strony)

CFG File Modification

This section describes some of the CFG file modifications that can be made to control the behavior of

Setup and the configuration output to the router.

The default connection type between the PC and the router can be set to either Ethernet or the console

cable. If the initial connection is set to be through the Ethernet and the connection fails, the user is

prompted to establish a connection through the console cable. If the initial connection is set to be

through the console cable and the connection fails, the user is prompted to retry the connection through

the console cable. The flag syntax is as follows:

[PC to Router Connection]

ConnectionType=

If the flag value is set to 2, the connection type defaults to Ethernet.

If the flag value is set to 3, the connection type defaults to the console cable.

You can force the end user to skip all data-entry windows and go directly to the configuration test. If

you have created a configuration that provides all the configuration parameters and you want the end

user to only use Setup to test the connection, you can skip all screens and display the Test window. The

flag syntax is as follows:

[Skipped Dialogs]

SkipToSetupandTest=

If the flag value is set to 0 or blank, the windows are displayed.

If the flag value is set to 1, Setup skips to the Test window.

You can skip testing and download the configuration to the router. This flag is often used when IOS

commands that do not follow the predefined Cisco 800 Fast Step scenarios are included in the

configuration. Although the configuration might be valid, it might fail testing because it is not based on

a recognized Cisco 800 Fast Step scenario. If you skip testing, the configurations are assumed to be

correct and are downloaded to the router. The flag syntax is as follows:

[Setup Type]

SetSkipTesting=

If the flag value is set to 0 or blank, the connections are tested.

If the flag value is set to 1, all the testing in Setup is skipped.

Cisco 800 Fast Step Software Design Guide

2-2

Chapter 2

CFG File Development

OL-10373-02